How do I install/remove the connector and cable?Updated 2 months ago

Tool & screws needed:

• Torx Key TX20 
• 4x M4x12 (3 Nm)

Steps to remove and install the connector and cable:

1. Loosen the four screws on the power cable connector.
2. Remove the connector.
3. Make sure the connector and the top plate of the new mast are clean and dry.
4. Attach the connector to the top plate of the new mast. Press it down gently so the male and female contacts lock securely.
5. Insert the four screws and tighten them.

⚠ Maintenance tip: If the connectors come into contact with sand, dirt, or water, rinse them thoroughly with fresh water, dry them completely, and then apply a thin layer of dielectric grease.