There's seawater residue in the mast pod area.Updated 2 months ago

If you notice seawater residue inside the mast pod area after a session, it’s important to address it promptly to prevent corrosion and ensure optimal performance of your Foil Assist system.

Possible Cause

Seawater can become trapped inside the mast pod area after use, especially if the equipment wasn’t rinsed thoroughly.

Recommended Actions

1. Disassemble the mast from the board and rinse it thoroughly with fresh water.
2. Flush the interior from the top plate downward, then turn the mast upside down to drain. Repeat this process as needed to remove all contaminants.
3. Dry completely by leaving the mast upside down, standing on the top plate.

Regular maintenance like this helps extend the life of your equipment and keeps it performing at its best.